user/sven/linux.git/Documentation/i2c, branch v3.8

Documentation: remove __dev* attributes.

2013-01-03T23:57:16Z

CONFIG_HOTPLUG is going away as an option. As a result, the __dev* markings need to be removed. This change removes the use of __devinit, __devexit_p, __devinitdata, __devinitconst, and __devexit from the kernel documentation. Based on patches originally written by Bill Pemberton, but redone by me in order to handle some of the coding style issues better, by hand. Cc: Bill Pemberton Signed-off-by: Greg Kroah-Hartman

i2c: Mention functionality flags in SMBus protocol documentation

2012-12-16T20:11:55Z

While the mapping between I2C adapter functionality flags and i2c_smbus_*() helper functions is rather obvious, let's still document it for clarity. Also drop the reference to 2 command byte I2C block reads, there is no support for that in the kernel at the moment. Signed-off-by: Jean Delvare

i2c-mux-gpio: Update documentation

2012-10-05T20:23:54Z

* Document the possibility to pass relative GPIO pin numbers. * Document what platform device IDs to use, so that they do not collide. Signed-off-by: Jean Delvare Cc: Peter Korsgaard

i2c-viapro: Add VIA VX900 device ID

2012-10-05T20:23:53Z

The SMBus controller in the VIA VX900 appears to be compatible with the VIA VX855, so just add the device ID. This closes kernel bug #43096. Signed-off-by: Jean Delvare

i2c-i801: Add Device IDs for Intel Lynx Point-LP PCH

2012-09-10T08:14:02Z

Add the SMBus Device IDs for the Intel Lynx Point-LP PCH. Signed-off-by: James Ralston Signed-off-by: Jean Delvare

i2c-i801: Enable IRQ for SMBus transactions

2012-07-24T12:13:58Z

Add a new 'feature' to i2c-i801 to enable using PCI interrupts. When the feature is enabled, then an isr is installed for the device's PCI IRQ. An I2C/SMBus transaction is always terminated by one of the following interrupt sources: FAILED, BUS_ERR, DEV_ERR, or on success: INTR. When the isr fires for one of these cases, it sets the ->status variable and wakes up the waitq. The waitq then saves off the status code, and clears ->status (in preparation for some future transaction). The SMBus controller generates an INTR irq at the end of each transaction where INTREN was set in the HST_CNT register. No locking is needed around accesses to priv->status since all writes to it are serialized: it is only ever set once in the isr at the end of a transaction, and cleared while no interrupts can occur. In addition, the I2C adapter lock guarantees that entire I2C transactions for a single adapter are always serialized. For this patch, the INTREN bit is set only for SMBus block, byte and word transactions, but not for I2C reads or writes. The use of the DS (BYTE_DONE) interrupt with byte-by-byte I2C transactions is implemented in a subsequent patch. The interrupt feature has only been enabled for COUGARPOINT hardware. In addition, it is disabled if SMBus is using the SMI# interrupt. Signed-off-by: Daniel Kurtz Signed-off-by: Jean Delvare

i2c/writing-clients: Mention module_i2c_driver()

2012-07-24T12:13:57Z

Based on a previous patch from Peter Meerwald. Signed-off-by: Jean Delvare Acked-by: Peter Meerwald

i2c-piix4: Support AMD auxiliary SMBus controller

2012-07-24T12:13:57Z

Some AMD chipsets, such as the SP5100, have an auxiliary SMBus controller with a second set of registers. This patch adds support for this auxiliary controller. Tested on ASUS KCMA-D8 motherboard. Signed-off-by: Andrew Armenia Signed-off-by: Jean Delvare

i2c: Split I2C_M_NOSTART support out of I2C_FUNC_PROTOCOL_MANGLING

2012-05-30T08:55:34Z

Since there are uses for I2C_M_NOSTART which are much more sensible and standard than most of the protocol mangling functionality (the main one being gather writes to devices where something like a register address needs to be inserted before a block of data) create a new I2C_FUNC_NOSTART for this feature and update all the users to use it. Also strengthen the disrecommendation of the protocol mangling while we're at it. In the case of regmap-i2c we remove the requirement for mangling as I2C_M_NOSTART is the only mangling feature which is being used. Signed-off-by: Mark Brown Acked-by: Wolfram Sang Signed-off-by: Jean Delvare

i2c: Rename last mux driver to standard pattern

2012-05-12T12:28:18Z

Update the MAINTAINERS entry and all other references accordingly. Based on an original patch by Wolfram Sang. Signed-off-by: Jean Delvare Acked-by: Peter Korsgaard [wsa: fixed merge conflict due to rework in i2c_add_mux_adapter()] Signed-off-by: Wolfram Sang