user/sven/linux.git/drivers/net/bonding, branch v4.9.46

bonding: fix accounting of active ports in 3ad

2017-06-07T10:07:45Z

[ Upstream commit 751da2a69b7cc82d83dc310ed7606225f2d6e014 ] As of 7bb11dc9f59d and 0622cab0341c, bond slaves in a 3ad bond are not removed from the aggregator when they are down, and the active slave count is NOT equal to number of ports in the aggregator, but rather the number of ports in the aggregator that are still enabled. The sysfs spew for bonding_show_ad_num_ports() has a comment that says "Show number of active 802.3ad ports.", but it's currently showing total number of ports, both active and inactive. Remedy it by using the same logic introduced in 0622cab0341c in __bond_3ad_get_active_agg_info(), so sysfs, procfs and netlink all report the number of active ports. Note that this means that IFLA_BOND_AD_INFO_NUM_PORTS really means NUM_ACTIVE_PORTS instead of NUM_PORTS, and thus perhaps should be renamed for clarity. Lightly tested on a dual i40e lacp bond, simulating link downs with an ip link set dev down, was able to produce the state where I could see both in the same aggregator, but a number of ports count of 1. MII Status: up Active Aggregator Info: Aggregator ID: 1 Number of ports: 2 <--- Slave Interface: ens10 MII Status: up <--- Aggregator ID: 1 Slave Interface: ens11 MII Status: up Aggregator ID: 1 MII Status: up Active Aggregator Info: Aggregator ID: 1 Number of ports: 1 <--- Slave Interface: ens10 MII Status: down <--- Aggregator ID: 1 Slave Interface: ens11 MII Status: up Aggregator ID: 1 CC: Jay Vosburgh CC: Veaceslav Falico CC: Andy Gospodarek CC: netdev@vger.kernel.org Signed-off-by: Jarod Wilson Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

Merge branch 'work.uaccess2' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs

2016-10-12T06:38:39Z

Pull uaccess.h prepwork from Al Viro: "Preparations to tree-wide switch to use of linux/uaccess.h (which, obviously, will allow to start unifying stuff for real). The last step there, ie PATT='^[[:blank:]]*#[[:blank:]]*include[[:blank:]]*' sed -i -e "s!$PATT!#include !" \ `git grep -l "$PATT"|grep -v ^include/linux/uaccess.h` is not taken here - I would prefer to do it once just before or just after -rc1. However, everything should be ready for it" * 'work.uaccess2' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs: remove a stray reference to asm/uaccess.h in docs sparc64: separate extable_64.h, switch elf_64.h to it score: separate extable.h, switch module.h to it mips: separate extable.h, switch module.h to it x86: separate extable.h, switch sections.h to it remove stray include of asm/uaccess.h from cacheflush.h mn10300: remove a bogus processor.h->uaccess.h include xtensa: split uaccess.h into C and asm sides bonding: quit messing with IOCTL kill __kernel_ds_p off mn10300: finish verify_area() off frv: move HAVE_ARCH_UNMAPPED_AREA to pgtable.h exceptions: detritus removal

bonding: quit messing with IOCTL

2016-09-28T01:15:21Z

The only remaining users are issuing SIOCGMIIPHY and SIOCGMIIREG, neither of which deals with userland pointers. Simply calling ->ndo_do_ioctl() is fine; no messing with set_fs() is needed. It used to mess with SIOCETHTOOL, which would've needed set_fs(), but that has been killed in "[NET] ethtool ops are the only way" 9 years ago... Signed-off-by: Al Viro

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2016-09-12T22:52:44Z

Conflicts: drivers/net/ethernet/mediatek/mtk_eth_soc.c drivers/net/ethernet/qlogic/qed/qed_dcbx.c drivers/net/phy/Kconfig All conflicts were cases of overlapping commits. Signed-off-by: David S. Miller

bonding: Fix bonding crash

2016-09-04T18:41:12Z

Following few steps will crash kernel - (a) Create bonding master > modprobe bonding miimon=50 (b) Create macvlan bridge on eth2 > ip link add link eth2 dev mvl0 address aa:0:0:0:0:01 \ type macvlan (c) Now try adding eth2 into the bond > echo +eth2 > /sys/class/net/bond0/bonding/slaves Bonding does lots of things before checking if the device enslaved is busy or not. In this case when the notifier call-chain sends notifications, the bond_netdev_event() assumes that the rx_handler /rx_handler_data is registered while the bond_enslave() hasn't progressed far enough to register rx_handler for the new slave. This patch adds a rx_handler check that can be performed right at the beginning of the enslave code to avoid getting into this situation. Signed-off-by: Mahesh Bandewar Acked-by: Eric Dumazet Signed-off-by: David S. Miller

bonding: Remove deprecated create_singlethread_workqueue

2016-09-01T23:41:07Z

alloc_ordered_workqueue() with WQ_MEM_RECLAIM set, replaces deprecated create_singlethread_workqueue(). This is the identity conversion. The workqueue "wq" queues multiple work items viz &bond->mcast_work, &nnw->work, &bond->mii_work, &bond->arp_work, &bond->alb_work, &bond->mii_work, &bond->ad_work, &bond->slave_arr_work which require strict execution ordering. Hence, an ordered dedicated workqueue has been used. Since, it is a network driver, WQ_MEM_RECLAIM has been set to ensure forward progress under memory pressure. Signed-off-by: Bhaktipriya Shridhar Acked-by: Tejun Heo Signed-off-by: David S. Miller

bonding: fix the typo

2016-08-09T21:57:14Z

The message "803.ad" should be "802.3ad". Signed-off-by: Zhu Yanjun Signed-off-by: David S. Miller

net/bonding: Enforce active-backup policy for IPoIB bonds

2016-07-25T17:18:58Z

When using an IPoIB bond currently only active-backup mode is a valid use case and this commit strengthens it. Since commit 2ab82852a270 ("net/bonding: Enable bonding to enslave netdevices not supporting set_mac_address()") was introduced till 4.7-rc1, IPoIB didn't support the set_mac_address ndo, and hence the fail over mac policy always applied to IPoIB bonds. With the introduction of commit 492a7e67ff83 ("IB/IPoIB: Allow setting the device address"), that doesn't hold and practically IPoIB bonds are broken as of that. To fix it, lets go to fail over mac if the device doesn't support the ndo OR this is IPoIB device. As a by-product, this commit also prevents a stack corruption which occurred when trying to copy 20 bytes (IPoIB) device address to a sockaddr struct that has only 16 bytes of storage. Signed-off-by: Mark Bloch Signed-off-by: Or Gerlitz Signed-off-by: Saeed Mahameed Acked-by: Andy Gospodarek Signed-off-by: Jay Vosburgh Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2016-07-24T04:53:32Z

Just several instances of overlapping changes. Signed-off-by: David S. Miller

bonding: set carrier off for devices created through netlink

2016-07-14T23:17:43Z

Commit e826eafa65c6 ("bonding: Call netif_carrier_off after register_netdevice") moved netif_carrier_off() from bond_init() to bond_create(), but the latter is called only for initial default devices and ones created through sysfs: $ modprobe bonding $ echo +bond1 > /sys/class/net/bonding_masters $ ip link add bond2 type bond $ grep "MII Status" /proc/net/bonding/* /proc/net/bonding/bond0:MII Status: down /proc/net/bonding/bond1:MII Status: down /proc/net/bonding/bond2:MII Status: up Ensure that carrier is initially off also for devices created through netlink. Signed-off-by: Beniamino Galvani Signed-off-by: David S. Miller