user/sven/linux.git/drivers/platform, branch v6.1.110

platform/x86: dell-smbios: Fix error path in dell_smbios_init()

2024-09-12T09:10:21Z

[ Upstream commit ffc17e1479e8e9459b7afa80e5d9d40d0dd78abb ] In case of error in build_tokens_sysfs(), all the memory that has been allocated is freed at end of this function. But then free_group() is called which performs memory deallocation again. Also, instead of free_group() call, there should be exit_dell_smbios_smm() and exit_dell_smbios_wmi() calls, since there is initialization, but there is no release of resources in case of an error. Fix these issues by replacing free_group() call with exit_dell_smbios_wmi() and exit_dell_smbios_smm(). Found by Linux Verification Center (linuxtesting.org) with SVACE. Fixes: 33b9ca1e53b4 ("platform/x86: dell-smbios: Add a sysfs interface for SMBIOS tokens") Signed-off-by: Aleksandr Mishin Link: https://lore.kernel.org/r/20240830065428.9544-1-amishin@t-argos.ru Reviewed-by: Ilpo Järvinen Signed-off-by: Ilpo Järvinen Signed-off-by: Sasha Levin

platform/surface: aggregator: Fix warning when controller is destroyed in probe

2024-08-29T15:30:42Z

[ Upstream commit bc923d594db21bee0ead128eb4bb78f7e77467a4 ] There is a small window in ssam_serial_hub_probe() where the controller is initialized but has not been started yet. Specifically, between ssam_controller_init() and ssam_controller_start(). Any failure in this window, for example caused by a failure of serdev_device_open(), currently results in an incorrect warning being emitted. In particular, any failure in this window results in the controller being destroyed via ssam_controller_destroy(). This function checks the state of the controller and, in an attempt to validate that the controller has been cleanly shut down before we try and deallocate any resources, emits a warning if that state is not SSAM_CONTROLLER_STOPPED. However, since we have only just initialized the controller and have not yet started it, its state is SSAM_CONTROLLER_INITIALIZED. Note that this is the only point at which the controller has this state, as it will change after we start the controller with ssam_controller_start() and never revert back. Further, at this point no communication has taken place and the sender and receiver threads have not been started yet (and we may not even have an open serdev device either). Therefore, it is perfectly safe to call ssam_controller_destroy() with a state of SSAM_CONTROLLER_INITIALIZED. This, however, means that the warning currently being emitted is incorrect. Fix it by extending the check. Fixes: c167b9c7e3d6 ("platform/surface: Add Surface Aggregator subsystem") Signed-off-by: Maximilian Luz Link: https://lore.kernel.org/r/20240811124645.246016-1-luzmaximilian@gmail.com Reviewed-by: Ilpo Järvinen Signed-off-by: Ilpo Järvinen Signed-off-by: Sasha Levin

platform/x86: lg-laptop: fix %s null argument warning

2024-08-29T15:30:40Z

[ Upstream commit e71c8481692582c70cdfd0996c20cdcc71e425d3 ] W=1 warns about null argument to kprintf: warning: ‘%s’ directive argument is null [-Wformat-overflow=] pr_info("product: %s year: %d\n", product, year); Use "unknown" instead of NULL. Signed-off-by: Gergo Koteles Reviewed-by: Kuppuswamy Sathyanarayanan Link: https://lore.kernel.org/r/33d40e976f08f82b9227d0ecae38c787fcc0c0b2.1712154684.git.soyer@irl.hu Reviewed-by: Ilpo Järvinen Signed-off-by: Ilpo Järvinen Signed-off-by: Sasha Levin

platform/x86/intel/ifs: Initialize union ifs_status to zero

2024-08-14T11:52:43Z

[ Upstream commit 3114f77e9453daa292ec0906f313a715c69b5943 ] If the IFS scan test exits prematurely due to a timeout before completing a single run, the union ifs_status remains uninitialized, leading to incorrect test status reporting. To prevent this, always initialize the union ifs_status to zero. Fixes: 2b40e654b73a ("platform/x86/intel/ifs: Add scan test support") Suggested-by: Ilpo Järvinen Reviewed-by: Jithu Joseph Reviewed-by: Ashok Raj Signed-off-by: Kuppuswamy Sathyanarayanan Link: https://lore.kernel.org/r/20240730155930.1754744-1-sathyanarayanan.kuppuswamy@linux.intel.com Reviewed-by: Ilpo Järvinen Signed-off-by: Ilpo Järvinen Signed-off-by: Sasha Levin

platform/x86/intel/ifs: Gen2 Scan test support

2024-08-14T11:52:43Z

[ Upstream commit 72b96ee29ed6f7670bbb180ba694816e33d361d1 ] Width of chunk related bitfields is ACTIVATE_SCAN and SCAN_STATUS MSRs are different in newer IFS generation compared to gen0. Make changes to scan test flow such that MSRs are populated appropriately based on the generation supported by hardware. Account for the 8/16 bit MSR bitfield width differences between gen0 and newer generations for the scan test trace event too. Signed-off-by: Jithu Joseph Reviewed-by: Tony Luck Reviewed-by: Ilpo Järvinen Tested-by: Pengfei Xu Link: https://lore.kernel.org/r/20231005195137.3117166-5-jithu.joseph@intel.com Signed-off-by: Ilpo Järvinen Stable-dep-of: 3114f77e9453 ("platform/x86/intel/ifs: Initialize union ifs_status to zero") Signed-off-by: Sasha Levin

platform/chrome: cros_ec_proto: Lock device when updating MKBP version

2024-08-11T10:35:59Z

commit df615907f1bf907260af01ccb904d0e9304b5278 upstream. The cros_ec_get_host_command_version_mask() function requires that the caller must have ec_dev->lock mutex before calling it. This requirement was not met and as a result it was possible that two commands were sent to the device at the same time. The problem was observed while using UART backend which doesn't use any additional locks, unlike SPI backend which locks the controller until response is received. Fixes: f74c7557ed0d ("platform/chrome: cros_ec_proto: Update version on GET_NEXT_EVENT failure") Cc: stable@vger.kernel.org Signed-off-by: Patryk Duda Link: https://lore.kernel.org/r/20240730104425.607083-1-patrykd@google.com Signed-off-by: Tzung-Bi Shih Signed-off-by: Greg Kroah-Hartman

platform: mips: cpu_hwmon: Disable driver on unsupported hardware

2024-08-03T06:49:43Z

commit f4d430db17b4ef4e9c3c352a04b2fe3c93011978 upstream. cpu_hwmon is unsupported on CPUs without loongson_chiptemp register and csr. Cc: stable@vger.kernel.org Signed-off-by: Jiaxun Yang Signed-off-by: Thomas Bogendoerfer Signed-off-by: Greg Kroah-Hartman

platform/chrome: cros_ec_debugfs: fix wrong EC message version

2024-08-03T06:48:52Z

[ Upstream commit c2a28647bbb4e0894e8824362410f72b06ac57a4 ] ec_read_version_supported() uses ec_params_get_cmd_versions_v1 but it wrongly uses message version 0. Fix it. Fixes: e86264595225 ("mfd: cros_ec: add debugfs, console log file") Reviewed-by: Guenter Roeck Link: https://lore.kernel.org/r/20240611113110.16955-1-tzungbi@kernel.org Signed-off-by: Tzung-Bi Shih Signed-off-by: Sasha Levin

platform/x86: lg-laptop: Use ACPI device handle when evaluating WMAB/WMBB

2024-07-25T07:49:16Z

[ Upstream commit b27ea279556121b54d3f45d0529706cf100cdb3a ] On the LG Gram 16Z90S, the WMAB and WMBB ACPI methods are not mapped under \XINI, but instead are mapped under \_SB.XINI. The reason for this is that the LGEX0820 ACPI device used by this driver is mapped at \_SB.XINI, so the ACPI methods where moved as well to appear below the LGEX0820 ACPI device. Fix this by using the ACPI handle from the ACPI device when evaluating both methods. Closes: https://bugzilla.kernel.org/show_bug.cgi?id=218901 Tested-by: Agathe Boutmy Signed-off-by: Armin Wolf Reviewed-by: Ilpo Järvinen Link: https://lore.kernel.org/r/20240606233540.9774-5-W_Armin@gmx.de Reviewed-by: Hans de Goede Signed-off-by: Hans de Goede Signed-off-by: Sasha Levin

platform/x86: lg-laptop: Change ACPI device id

2024-07-25T07:49:16Z

[ Upstream commit 58a54f27a0dac81f7fd3514be01012635219a53c ] The LGEX0815 ACPI device id is used for handling hotkey events, but this functionality is already handled by the wireless-hotkey driver. The LGEX0820 ACPI device id however is used to manage various platform features using the WMAB/WMBB ACPI methods. Use this ACPI device id to avoid blocking the wireless-hotkey driver from probing. Tested-by: Agathe Boutmy Signed-off-by: Armin Wolf Reviewed-by: Ilpo Järvinen Link: https://lore.kernel.org/r/20240606233540.9774-4-W_Armin@gmx.de Reviewed-by: Hans de Goede Signed-off-by: Hans de Goede Signed-off-by: Sasha Levin