user/sven/linux.git/include/linux/ath9k_platform.h, branch v3.12.33

ath9k: allow to load EEPROM content via firmware API

2012-12-10T20:49:57Z

The calibration data for devices w/o a separate EEPROM chip can be specified via the 'eeprom_data' field of 'ath9k_platform_data'. The 'eeprom_data' is usually filled from board specific setup functions. It is easy if the EEPROM data is mapped to the memory, but it can be complicated if it is stored elsewhere. The patch adds support for loading of the EEPROM data via the firmware API to avoid this limitation. Signed-off-by: Gabor Juhos Signed-off-by: John W. Linville

ath9k: add external_reset callback to ath9k_platfom_data for AR9330

2011-06-22T20:09:57Z

The patch adds a callback to ath9k_platform_data. If the callback is provided by the platform code, then it can be used to hard reset the WMAC device. The callback is required for doing a hard reset of the AR9330 chips to get them working again after a hang. Signed-off-by: Gabor Juhos Signed-off-by: John W. Linville

ath9k: add MAC revision detection for AR9330

2011-06-22T20:09:49Z

The AR9330 1.0 and 1.1 are using the same revision, thus it is not possible to distinguish the two chips. The platform setup code can distinguish the chips based on the SoC revision. Add a callback function to ath9k_platform_data in order to allow getting the revision number from the platform code. Signed-off-by: Gabor Juhos Signed-off-by: John W. Linville

ath9k_hw: Get AHB clock information from ath9k_platform_data

2011-04-25T18:50:08Z

Add a bool in ath9k_platform_data to pass AHB clock speed information. Driver needs this to configure PLL on some SOCs. Signed-off-by: Vasanthakumar Thiagarajan Signed-off-by: John W. Linville

ath9k: add support for overriding LED pin and GPIO settings from platform data

2011-03-30T18:15:15Z

Signed-off-by: Felix Fietkau Signed-off-by: John W. Linville

ath9k: add support for overriding the MAC address through platform data

2011-03-30T18:15:15Z

On some devices the correct MAC address is not in the EEPROM data, but stored somewhere else. Signed-off-by: Felix Fietkau Signed-off-by: John W. Linville

ath9k: get EEPROM contents from platform data on AHB bus

2009-01-29T21:00:33Z

On the AR913x SOCs we have to provide EEPROM contents via platform_data, because accessing the flash via MMIO is not safe. Additionally different boards may store the radio calibration data at different locations. Changes-licensed-under: ISC Signed-off-by: Gabor Juhos Signed-off-by: Imre Kaloz Tested-by: Pavel Roskin Signed-off-by: John W. Linville