user/sven/linux.git/include/linux/msi.h, branch v4.9.46

genirq/msi: Add cpumask allocation to alloc_msi_entry

2016-09-14T20:11:08Z

For irq spreading want to store affinity masks in the msi_entry. Add the infrastructure for it. We allocate an array of cpumasks with an array size of the number of used vectors in the entry, so we can hand in the information per linux interrupt later. As we hand in the number of used vectors, we assign them right away. Convert all the call sites. Signed-off-by: Thomas Gleixner Cc: axboe@fb.com Cc: keith.busch@intel.com Cc: agordeev@redhat.com Cc: linux-block@vger.kernel.org Cc: Christoph Hellwig Link: http://lkml.kernel.org/r/1473862739-15032-2-git-send-email-hch@lst.de

genirq/msi: Make sure PCI MSIs are activated early

2016-08-09T07:19:32Z

Bharat Kumar Gogada reported issues with the generic MSI code, where the end-point ended up with garbage in its MSI configuration (both for the vector and the message). It turns out that the two MSI paths in the kernel are doing slightly different things: generic MSI: disable MSI -> allocate MSI -> enable MSI -> setup EP PCI MSI: disable MSI -> allocate MSI -> setup EP -> enable MSI And it turns out that end-points are allowed to latch the content of the MSI configuration registers as soon as MSIs are enabled. In Bharat's case, the end-point ends up using whatever was there already, which is not what you want. In order to make things converge, we introduce a new MSI domain flag (MSI_FLAG_ACTIVATE_EARLY) that is unconditionally set for PCI/MSI. When set, this flag forces the programming of the end-point as soon as the MSIs are allocated. A consequence of this is that we have an extra activate in irq_startup, but that should be without much consequence. tglx: - Several people reported a VMWare regression with PCI/MSI-X passthrough. It turns out that the patch also cures that issue. - We need to have a look at the MSI disable interrupt path, where we write the msg to all zeros without disabling MSI in the PCI device. Is that correct? Fixes: 52f518a3a7c2 "x86/MSI: Use hierarchical irqdomains to manage MSI interrupts" Reported-and-tested-by: Bharat Kumar Gogada Reported-and-tested-by: Foster Snowhill Reported-by: Matthias Prager Reported-by: Jason Taylor Signed-off-by: Marc Zyngier Acked-by: Bjorn Helgaas Cc: linux-pci@vger.kernel.org Cc: stable@vger.kernel.org Link: http://lkml.kernel.org/r/1468426713-31431-1-git-send-email-marc.zyngier@arm.com Signed-off-by: Thomas Gleixner

genirq/msi: Make use of affinity aware allocations

2016-07-04T10:25:14Z

Allow the MSI code to provide affinity hints per MSI descriptor. Signed-off-by: Thomas Gleixner Cc: Christoph Hellwig Cc: linux-block@vger.kernel.org Cc: linux-pci@vger.kernel.org Cc: linux-nvme@lists.infradead.org Cc: axboe@fb.com Cc: agordeev@redhat.com Link: http://lkml.kernel.org/r/1467621574-8277-6-git-send-email-hch@lst.de Signed-off-by: Thomas Gleixner

genirq/msi: Remove unused MSI_FLAG_IDENTITY_MAP

2016-07-04T10:25:12Z

No user and we definitely don't want to grow one. Signed-off-by: Thomas Gleixner Reviewed-by: Bart Van Assche Cc: Christoph Hellwig Cc: linux-block@vger.kernel.org Cc: linux-pci@vger.kernel.org Cc: linux-nvme@lists.infradead.org Cc: axboe@fb.com Cc: agordeev@redhat.com Link: http://lkml.kernel.org/r/1467621574-8277-2-git-send-email-hch@lst.de Signed-off-by: Thomas Gleixner

fsl-mc: msi: Added FSL-MC-specific member to the msi_desc's union

2016-02-08T03:10:12Z

FSL-MC is a bus type different from PCI and platform, so it needs its own member in the msi_desc's union. Signed-off-by: J. German Rivera Signed-off-by: Greg Kroah-Hartman

Merge tag 'pci-v4.5-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci

2016-01-21T19:52:16Z

Pull PCI updates from Bjorn Helgaas: "PCI changes for the v4.5 merge window: Enumeration: - Simplify config space size computation (Bjorn Helgaas) - Avoid iterating through ROM outside the resource window (Edward O'Callaghan) - Support PCIe devices with short cfg_size (Jason S. McMullan) - Add Netronome vendor and device IDs (Jason S. McMullan) - Limit config space size for Netronome NFP6000 family (Jason S. McMullan) - Add Netronome NFP4000 PF device ID (Simon Horman) - Limit config space size for Netronome NFP4000 (Simon Horman) - Print warnings for all invalid expansion ROM headers (Vladis Dronov) Resource management: - Fix minimum allocation address overwrite (Christoph Biedl) PCI device hotplug: - acpiphp_ibm: Fix null dereferences on null ibm_slot (Colin Ian King) - pciehp: Always protect pciehp_disable_slot() with hotplug mutex (Guenter Roeck) - shpchp: Constify hpc_ops structure (Julia Lawall) - ibmphp: Remove unneeded NULL test (Julia Lawall) Power management: - Make ASPM sysfs link_state_store() consistent with link_state_show() (Andy Lutomirski) Virtualization - Add function 1 DMA alias quirk for Lite-On/Plextor M6e/Marvell 88SS9183 (Tim Sander) MSI: - Remove empty pci_msi_init_pci_dev() (Bjorn Helgaas) - Mark PCIe/PCI (MSI) IRQ cascade handlers as IRQF_NO_THREAD (Grygorii Strashko) - Initialize MSI capability for all architectures (Guilherme G. Piccoli) - Relax msi_domain_alloc() to support parentless MSI irqdomains (Liu Jiang) ARM Versatile host bridge driver: - Remove unused pci_sys_data structures (Lorenzo Pieralisi) Broadcom iProc host bridge driver: - Hide CONFIG_PCIE_IPROC (Arnd Bergmann) - Do not use 0x in front of %pap (Dmitry V. Krivenok) - Update iProc PCIe device tree binding (Ray Jui) - Add PAXC interface support (Ray Jui) - Add iProc PCIe MSI device tree binding (Ray Jui) - Add iProc PCIe MSI support (Ray Jui) Freescale i.MX6 host bridge driver: - Use gpio_set_value_cansleep() (Fabio Estevam) - Add support for active-low reset GPIO (Petr Štetiar) HiSilicon host bridge driver: - Add support for HiSilicon Hip06 PCIe host controllers (Gabriele Paoloni) Intel VMD host bridge driver: - Export irq_domain_set_info() for module use (Keith Busch) - x86/PCI: Allow DMA ops specific to a PCI domain (Keith Busch) - Use 32 bit PCI domain numbers (Keith Busch) - Add driver for Intel Volume Management Device (VMD) (Keith Busch) Qualcomm host bridge driver: - Document PCIe devicetree bindings (Stanimir Varbanov) - Add Qualcomm PCIe controller driver (Stanimir Varbanov) - dts: apq8064: add PCIe devicetree node (Stanimir Varbanov) - dts: ifc6410: enable PCIe DT node for this board (Stanimir Varbanov) Renesas R-Car host bridge driver: - Add support for R-Car H3 to pcie-rcar (Harunobu Kurokawa) - Allow DT to override default window settings (Phil Edworthy) - Convert to DT resource parsing API (Phil Edworthy) - Revert "PCI: rcar: Build pcie-rcar.c only on ARM" (Phil Edworthy) - Remove unused pci_sys_data struct from pcie-rcar (Phil Edworthy) - Add runtime PM support to pcie-rcar (Phil Edworthy) - Add Gen2 PHY setup to pcie-rcar (Phil Edworthy) - Add gen2 fallback compatibility string for pci-rcar-gen2 (Simon Horman) - Add gen2 fallback compatibility string for pcie-rcar (Simon Horman) Synopsys DesignWare host bridge driver: - Simplify control flow (Bjorn Helgaas) - Make config accessor override checking symmetric (Bjorn Helgaas) - Ensure ATU is enabled before IO/conf space accesses (Stanimir Varbanov) Miscellaneous: - Add of_pci_get_host_bridge_resources() stub (Arnd Bergmann) - Check for PCI_HEADER_TYPE_BRIDGE equality, not bitmask (Bjorn Helgaas) - Fix all whitespace issues (Bogicevic Sasa) - x86/PCI: Simplify pci_bios_{read,write} (Geliang Tang) - Use to_pci_dev() instead of open-coding it (Geliang Tang) - Use kobj_to_dev() instead of open-coding it (Geliang Tang) - Use list_for_each_entry() to simplify code (Geliang Tang) - Fix typos in (Thomas Petazzoni) - x86/PCI: Clarify AMD Fam10h config access restrictions comment (Tomasz Nowicki)" * tag 'pci-v4.5-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci: (58 commits) PCI: Add function 1 DMA alias quirk for Lite-On/Plextor M6e/Marvell 88SS9183 PCI: Limit config space size for Netronome NFP4000 PCI: Add Netronome NFP4000 PF device ID x86/PCI: Add driver for Intel Volume Management Device (VMD) PCI/AER: Use 32 bit PCI domain numbers x86/PCI: Allow DMA ops specific to a PCI domain irqdomain: Export irq_domain_set_info() for module use PCI: host: Add of_pci_get_host_bridge_resources() stub genirq/MSI: Relax msi_domain_alloc() to support parentless MSI irqdomains PCI: rcar: Add Gen2 PHY setup to pcie-rcar PCI: rcar: Add runtime PM support to pcie-rcar PCI: designware: Make config accessor override checking symmetric PCI: ibmphp: Remove unneeded NULL test ARM: dts: ifc6410: enable PCIe DT node for this board ARM: dts: apq8064: add PCIe devicetree node PCI: hotplug: Use list_for_each_entry() to simplify code PCI: rcar: Remove unused pci_sys_data struct from pcie-rcar PCI: hisi: Add support for HiSilicon Hip06 PCIe host controllers PCI: Avoid iterating through memory outside the resource window PCI: acpiphp_ibm: Fix null dereferences on null ibm_slot ...

PCI/MSI: Fix typos in

2016-01-07T17:46:31Z

Fix two comment typos in the header. Signed-off-by: Thomas Petazzoni Signed-off-by: Bjorn Helgaas

platform-msi: Allow creation of a MSI-based stacked irq domain

2015-12-16T15:29:44Z

We almost have all the needed bits requiredable to create a irq domain on top of a MSI domain. For this, we enable a few things: - the virq is stored in the msi_desc - device, msi_alloc_info and domain-specific data are stored in the platform_priv_data structure - we introduce a new API for platform-msi: /* Create a MSI-based domain */ struct irq_domain * platform_msi_create_device_domain(struct device *dev, unsigned int nvec, irq_write_msi_msg_t write_msi_msg, const struct irq_domain_ops *ops, void *host_data); /* Allocate MSIs in an MSI domain */ int platform_msi_domain_alloc(struct irq_domain *domain, unsigned int virq, unsigned int nr_irqs); /* Free MSIs from an MSI domain */ void platform_msi_domain_free(struct irq_domain *domain, unsigned int virq, unsigned int nvec); /* Obtain the host data passed to platform_msi_create_device_domain */ void *platform_msi_get_host_data(struct irq_domain *domain); platform_msi_create_device_domain() is a hybrid of irqdomain creation and interrupt allocation, creating a domain backed by the MSIs associated to a device. IRQs can then be allocated in that domain using platform_msi_domain_alloc(). This now allows a wired irq to MSI bridge to be created. Signed-off-by: Marc Zyngier

genirq/msi: Add msi_domain_populate_irqs

2015-12-16T15:29:44Z

To be able to allocate interrupts from the MSI layer down, add a new msi_domain_populate_irqs entry point. Signed-off-by: Marc Zyngier

genirq/msi: Make the .prepare callback reusable

2015-12-16T15:29:44Z

The .prepare callbacks are so far only called from msi_domain_alloc_irqs. In order to reuse that code, split that code and create a msi_domain_prepare_irqs function that the existing code can call into. Signed-off-by: Marc Zyngier