user/sven/linux.git/include/linux/mtd, branch v6.13.1

Merge tag 'mtd/for-6.13' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux

2024-11-23T01:06:59Z

Pull MTD updates from Miquel Raynal: "MTD device changes: - switch platform_driver back to remove() - misc fixes SPI-NAND changes: - a load of fixes to Winbond manufacturer driver - structure constification Raw NAND changes: - improve the power management of the GPMI driver - Davinci driver clean-ups - fix leak in the Atmel driver - fix some typos in the core SPI NOR changes: - Introduce byte swap support for 8D-8D-8D mode and a user for it: macronix. SPI NOR flashes may swap the bytes on a 16-bit boundary when configured in Octal DTR mode. For such cases the byte order is propagated through SPI MEM to the SPI controllers so that the controllers swap the bytes back at runtime. This avoids breaking the boot sequence because of the endianness problems that appear when the bootloaders use 1-1-1 and the kernel uses 8D-8D-8D with byte swap support. Along with the SPI MEM byte swap support we queue a patch for the SPI MXIC controller that swaps the bytes back at runtime" * tag 'mtd/for-6.13' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux: (25 commits) mtd: spi-nor: core: replace dummy buswidth from addr to data mtd: spi-nor: winbond: add "w/ and w/o SFDP" comment mtd: spi-nor: spansion: Use nor->addr_nbytes in octal DTR mode in RD_ANY_REG_OP mtd: Switch back to struct platform_driver::remove() mtd: cfi_cmdset_0002: remove redundant assignment to variable ret mtd: spinand: Constify struct nand_ecc_engine_ops MAINTAINERS: add mailing list for GPMI NAND driver mtd: spinand: winbond: Sort the devices mtd: spinand: winbond: Ignore the last ID characters mtd: spinand: winbond: Fix 512GW, 01GW, 01JW and 02JW ECC information mtd: spinand: winbond: Fix 512GW and 02JW OOB layout mtd: nand: raw: gpmi: improve power management handling mtd: nand: raw: gpmi: switch to SYSTEM_SLEEP_PM_OPS mtd: rawnand: davinci: use generic device property helpers mtd: rawnand: davinci: break the line correctly mtd: rawnand: davinci: order headers alphabetically mtd: rawnand: atmel: Fix possible memory leak mtd: rawnand: Correct multiple typos in comments mtd: hyperbus: rpc-if: Add missing MODULE_DEVICE_TABLE mtd: spi-nor: add support for Macronix Octal flash ...

mtd: spinand: Constify struct nand_ecc_engine_ops

2024-10-21T09:55:50Z

'struct nand_ecc_engine_ops' are not modified in these drivers. Constifying this structure moves some data to a read-only section, so increases overall security, especially when the structure holds some function pointers. Update the prototype of mxic_ecc_get_pipelined_ops() accordingly. On a x86_64, with allmodconfig, as an example: Before: ====== text data bss dec hex filename 16709 1374 16 18099 46b3 drivers/mtd/nand/ecc-mxic.o After: ===== text data bss dec hex filename 16789 1294 16 18099 46b3 drivers/mtd/nand/ecc-mxic.o Signed-off-by: Christophe JAILLET Signed-off-by: Miquel Raynal Link: https://lore.kernel.org/linux-mtd/72597e9de2320a4109be2112e696399592edacd4.1729271136.git.christophe.jaillet@wanadoo.fr

move asm/unaligned.h to linux/unaligned.h

2024-10-02T21:23:23Z

asm/unaligned.h is always an include of asm-generic/unaligned.h; might as well move that thing to linux/unaligned.h and include that - there's nothing arch-specific in that header. auto-generated by the following: for i in `git grep -l -w asm/unaligned.h`; do sed -i -e "s/asm\/unaligned.h/linux\/unaligned.h/" $i done for i in `git grep -l -w asm-generic/unaligned.h`; do sed -i -e "s/asm-generic\/unaligned.h/linux\/unaligned.h/" $i done git mv include/asm-generic/unaligned.h include/linux/unaligned.h git mv tools/include/asm-generic/unaligned.h tools/include/linux/unaligned.h sed -i -e "/unaligned.h/d" include/asm-generic/Kbuild sed -i -e "s/__ASM_GENERIC/__LINUX/" include/linux/unaligned.h tools/include/linux/unaligned.h

mtd: spinand: Add support for setting plane select bits

2024-09-09T09:52:06Z

Add two flags for inserting the Plane Select bit into the column address during the write_to_cache and the read_from_cache operation. Add the SPINAND_HAS_PROG_PLANE_SELECT_BIT flag for serial NAND flash that require inserting the Plane Select bit into the column address during the write_to_cache operation. Add the SPINAND_HAS_READ_PLANE_SELECT_BIT flag for serial NAND flash that require inserting the Plane Select bit into the column address during the read_from_cache operation. Signed-off-by: Cheng Ming Lin Signed-off-by: Miquel Raynal Link: https://lore.kernel.org/linux-mtd/20240909092643.2434479-2-linchengming884@gmail.com

mtd: spi-nand: Expose spinand_write_reg_op()

2024-09-06T15:00:08Z

This helper function will soon be used from a vendor driver, let's export it through the spinand.h header. No need for any export, as there is currently no reason for any module to need it. Signed-off-by: Miquel Raynal Link: https://lore.kernel.org/linux-mtd/20240826101412.20644-6-miquel.raynal@bootlin.com

mtd: spi-nand: Add continuous read support

2024-09-06T15:00:06Z

A regular page read consist in: - Asking one page of content from the NAND array to be loaded in the chip's SRAM, - Waiting for the operation to be done, - Retrieving the data (I/O phase) from the chip's SRAM. When reading several sequential pages, the above operation is repeated over and over. There is however a way to optimize these accesses, by enabling continuous reads. The feature requires the NAND chip to have a second internal SRAM area plus a bit of additional internal logic to trigger another internal transfer between the NAND array and the second SRAM area while the I/O phase is ongoing. Once the first I/O phase is done, the host can continue reading more data, continuously, as the chip will automatically switch to the second SRAM content (which has already been loaded) and in turns trigger the next load into the first SRAM area again. From an instruction perspective, the command op-codes are different, but the same cycles are required. The only difference is that after a continuous read (which is stopped by a CS deassert), the host must observe a delay of tRST. However, because there is no guarantee in Linux regarding the actual state of the CS pin after a transfer (in order to speed-up the next transfer if targeting the same device), it was necessary to manually end the continuous read with a configuration register write operation. Continuous reads have two main drawbacks: * They only work on full pages (column address ignored) * Only the main data area is pulled, out-of-band bytes are not accessible. Said otherwise, the feature can only be useful with on-die ECC engines. Performance wise, measures have been performed on a Zynq platform using Macronix SPI-NAND controller with a Macronix chip (based on the flash_speed tool modified for testing sequential reads): - 1-1-1 mode: performances improved from +3% (2-pages) up to +10% after a dozen pages. - 1-1-4 mode: performances improved from +15% (2-pages) up to +40% after a dozen pages. This series is based on a previous work from Macronix engineer Jaime Liao. Signed-off-by: Miquel Raynal Reviewed-by: Pratyush Yadav Link: https://lore.kernel.org/linux-mtd/20240826101412.20644-5-miquel.raynal@bootlin.com

mtd: nand: Introduce a block iterator

2024-09-06T15:00:02Z

In order to be able to iterate easily across eraseblocks rather than pages, let's introduce a block iterator inspired from the page iterator. The main usage of this iterator will be for continuous/sequential reads, where it is interesting to use a single request rather than split the requests in smaller chunks (ie. pages) that can be hardly optimized. So a "continuous" boolean get's added for this purpose. Signed-off-by: Miquel Raynal Link: https://lore.kernel.org/linux-mtd/20240826101412.20644-3-miquel.raynal@bootlin.com

mtd: nand: Rename the NAND IO iteration helper

2024-09-06T15:00:00Z

Soon a helper for iterating over blocks will be needed (for continuous read purposes). In order to clarify the intend of this helper, let's rename it with the "page" wording inside. While at it, improve the doc and fix a typo. Signed-off-by: Miquel Raynal Reviewed-by: Pratyush Yadav Link: https://lore.kernel.org/linux-mtd/20240826101412.20644-2-miquel.raynal@bootlin.com

mtd: cfi: Get rid of redundant 'else'

2024-05-27T11:39:51Z

In the snippets like the following if (...) return / goto / break / continue ...; else ... the 'else' is redundant. Get rid of it. Signed-off-by: Andy Shevchenko Reviewed-by: Jeff Johnson Signed-off-by: Miquel Raynal Link: https://lore.kernel.org/linux-mtd/20240503184230.2927283-1-andriy.shevchenko@linux.intel.com

Merge tag 'ubifs-for-linus-6.9-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/rw/ubifs

2024-03-21T22:09:29Z

Pull UBI and UBIFS updates from Richard Weinberger: "UBI: - Add Zhihao Cheng as reviewer - Attach via device tree - Add NVMEM layer - Various fastmap related fixes UBIFS: - Add Zhihao Cheng as reviewer - Convert to folios - Various fixes (memory leaks in error paths, function prototypes)" * tag 'ubifs-for-linus-6.9-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/rw/ubifs: (34 commits) mtd: ubi: fix NVMEM over UBI volumes on 32-bit systems mtd: ubi: provide NVMEM layer over UBI volumes mtd: ubi: populate ubi volume fwnode mtd: ubi: introduce pre-removal notification for UBI volumes mtd: ubi: attach from device tree mtd: ubi: block: use notifier to create ubiblock from parameter dt-bindings: mtd: ubi-volume: allow UBI volumes to provide NVMEM dt-bindings: mtd: add basic bindings for UBI ubifs: Queue up space reservation tasks if retrying many times ubifs: ubifs_symlink: Fix memleak of inode->i_link in error path ubifs: dbg_check_idx_size: Fix kmemleak if loading znode failed ubi: Correct the number of PEBs after a volume resize failure ubi: fix slab-out-of-bounds in ubi_eba_get_ldesc+0xfb/0x130 ubi: correct the calculation of fastmap size ubifs: Remove unreachable code in dbg_check_ltab_lnum ubifs: fix function pointer cast warnings ubifs: fix sort function prototype ubi: Check for too small LEB size in VTBL code MAINTAINERS: Add Zhihao Cheng as UBI/UBIFS reviewer ubifs: Convert populate_page() to take a folio ...