user/sven/linux.git/mm/compaction.c, branch v3.8

mm: compaction: partially revert capture of suitable high-order page

2013-01-11T22:54:56Z

Eric Wong reported on 3.7 and 3.8-rc2 that ppoll() got stuck when waiting for POLLIN on a local TCP socket. It was easier to trigger if there was disk IO and dirty pages at the same time and he bisected it to commit 1fb3f8ca0e92 ("mm: compaction: capture a suitable high-order page immediately when it is made available"). The intention of that patch was to improve high-order allocations under memory pressure after changes made to reclaim in 3.6 drastically hurt THP allocations but the approach was flawed. For Eric, the problem was that page->pfmemalloc was not being cleared for captured pages leading to a poor interaction with swap-over-NFS support causing the packets to be dropped. However, I identified a few more problems with the patch including the fact that it can increase contention on zone->lock in some cases which could result in async direct compaction being aborted early. In retrospect the capture patch took the wrong approach. What it should have done is mark the pageblock being migrated as MIGRATE_ISOLATE if it was allocating for THP and avoided races that way. While the patch was showing to improve allocation success rates at the time, the benefit is marginal given the relative complexity and it should be revisited from scratch in the context of the other reclaim-related changes that have taken place since the patch was first written and tested. This patch partially reverts commit 1fb3f8ca0e92 ("mm: compaction: capture a suitable high-order page immediately when it is made available"). Reported-and-tested-by: Eric Wong Tested-by: Eric Dumazet Cc: Signed-off-by: Mel Gorman Cc: David Miller Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

mm: compaction: fix echo 1 > compact_memory return error issue

2013-01-11T22:54:54Z

when run the folloing command under shell, it will return error sh/$ echo 1 > /proc/sys/vm/compact_memory sh/$ sh: write error: Bad address After strace, I found the following log: ... write(1, "1\n", 2) = 3 write(1, "", 4294967295) = -1 EFAULT (Bad address) write(2, "echo: write error: Bad address\n", 31echo: write error: Bad address ) = 31 This tells system return 3(COMPACT_COMPLETE) after write data to compact_memory. The fix is to make the system just return 0 instead 3(COMPACT_COMPLETE) from sysctl_compaction_handler after compaction_nodes finished. Signed-off-by: Jason Liu Suggested-by: David Rientjes Acked-by: Mel Gorman Cc: Rik van Riel Cc: Minchan Kim Cc: KAMEZAWA Hiroyuki Acked-by: David Rientjes Cc: Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

compaction: fix build error in CMA && !COMPACTION

2012-12-21T01:40:18Z

isolate_freepages_block() and isolate_migratepages_range() are used for CMA as well as compaction so it breaks build for CONFIG_CMA && !CONFIG_COMPACTION. This patch fixes it. [akpm@linux-foundation.org: add "do { } while (0)", per Mel] Signed-off-by: Minchan Kim Cc: Mel Gorman Cc: Marek Szyprowski Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

Merge tag 'balancenuma-v11' of git://git.kernel.org/pub/scm/linux/kernel/git/mel/linux-balancenuma

2012-12-16T23:18:08Z

Pull Automatic NUMA Balancing bare-bones from Mel Gorman: "There are three implementations for NUMA balancing, this tree (balancenuma), numacore which has been developed in tip/master and autonuma which is in aa.git. In almost all respects balancenuma is the dumbest of the three because its main impact is on the VM side with no attempt to be smart about scheduling. In the interest of getting the ball rolling, it would be desirable to see this much merged for 3.8 with the view to building scheduler smarts on top and adapting the VM where required for 3.9. The most recent set of comparisons available from different people are mel: https://lkml.org/lkml/2012/12/9/108 mingo: https://lkml.org/lkml/2012/12/7/331 tglx: https://lkml.org/lkml/2012/12/10/437 srikar: https://lkml.org/lkml/2012/12/10/397 The results are a mixed bag. In my own tests, balancenuma does reasonably well. It's dumb as rocks and does not regress against mainline. On the other hand, Ingo's tests shows that balancenuma is incapable of converging for this workloads driven by perf which is bad but is potentially explained by the lack of scheduler smarts. Thomas' results show balancenuma improves on mainline but falls far short of numacore or autonuma. Srikar's results indicate we all suffer on a large machine with imbalanced node sizes. My own testing showed that recent numacore results have improved dramatically, particularly in the last week but not universally. We've butted heads heavily on system CPU usage and high levels of migration even when it shows that overall performance is better. There are also cases where it regresses. Of interest is that for specjbb in some configurations it will regress for lower numbers of warehouses and show gains for higher numbers which is not reported by the tool by default and sometimes missed in treports. Recently I reported for numacore that the JVM was crashing with NullPointerExceptions but currently it's unclear what the source of this problem is. Initially I thought it was in how numacore batch handles PTEs but I'm no longer think this is the case. It's possible numacore is just able to trigger it due to higher rates of migration. These reports were quite late in the cycle so I/we would like to start with this tree as it contains much of the code we can agree on and has not changed significantly over the last 2-3 weeks." * tag 'balancenuma-v11' of git://git.kernel.org/pub/scm/linux/kernel/git/mel/linux-balancenuma: (50 commits) mm/rmap, migration: Make rmap_walk_anon() and try_to_unmap_anon() more scalable mm/rmap: Convert the struct anon_vma::mutex to an rwsem mm: migrate: Account a transhuge page properly when rate limiting mm: numa: Account for failed allocations and isolations as migration failures mm: numa: Add THP migration for the NUMA working set scanning fault case build fix mm: numa: Add THP migration for the NUMA working set scanning fault case. mm: sched: numa: Delay PTE scanning until a task is scheduled on a new node mm: sched: numa: Control enabling and disabling of NUMA balancing if !SCHED_DEBUG mm: sched: numa: Control enabling and disabling of NUMA balancing mm: sched: Adapt the scanning rate if a NUMA hinting fault does not migrate mm: numa: Use a two-stage filter to restrict pages being migrated for unlikely task<->node relationships mm: numa: migrate: Set last_nid on newly allocated page mm: numa: split_huge_page: Transfer last_nid on tail page mm: numa: Introduce last_nid to the page frame sched: numa: Slowly increase the scanning period as NUMA faults are handled mm: numa: Rate limit setting of pte_numa if node is saturated mm: numa: Rate limit the amount of memory that is migrated between nodes mm: numa: Structures for Migrate On Fault per NUMA migration rate limiting mm: numa: Migrate pages handled during a pmd_numa hinting fault mm: numa: Migrate on reference policy ...

mm: compaction: Fix compiler warning

2012-12-13T01:38:32Z

compact_capture_page() is only used if compaction is enabled so it should be moved into the corresponding #ifdef. Signed-off-by: Thierry Reding Acked-by: Mel Gorman Cc: Rik van Riel Cc: Minchan Kim Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

mm: introduce putback_movable_pages()

2012-12-12T01:22:27Z

The PATCH "mm: introduce compaction and migration for virtio ballooned pages" hacks around putback_lru_pages() in order to allow ballooned pages to be re-inserted on balloon page list as if a ballooned page was like a LRU page. As ballooned pages are not legitimate LRU pages, this patch introduces putback_movable_pages() to properly cope with cases where the isolated pageset contains ballooned pages and LRU pages, thus fixing the mentioned inelegant hack around putback_lru_pages(). Signed-off-by: Rafael Aquini Cc: Rusty Russell Cc: "Michael S. Tsirkin" Cc: Rik van Riel Cc: Mel Gorman Cc: Andi Kleen Cc: Konrad Rzeszutek Wilk Cc: Minchan Kim Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

mm: introduce compaction and migration for ballooned pages

2012-12-12T01:22:27Z

Memory fragmentation introduced by ballooning might reduce significantly the number of 2MB contiguous memory blocks that can be used within a guest, thus imposing performance penalties associated with the reduced number of transparent huge pages that could be used by the guest workload. This patch introduces the helper functions as well as the necessary changes to teach compaction and migration bits how to cope with pages which are part of a guest memory balloon, in order to make them movable by memory compaction procedures. Signed-off-by: Rafael Aquini Acked-by: Mel Gorman Cc: Rusty Russell Cc: "Michael S. Tsirkin" Cc: Rik van Riel Cc: Andi Kleen Cc: Konrad Rzeszutek Wilk Cc: Minchan Kim Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

mm: compaction: Add scanned and isolated counters for compaction

2012-12-11T14:28:35Z

Compaction already has tracepoints to count scanned and isolated pages but it requires that ftrace be enabled and if that information has to be written to disk then it can be disruptive. This patch adds vmstat counters for compaction called compact_migrate_scanned, compact_free_scanned and compact_isolated. With these counters, it is possible to define a basic cost model for compaction. This approximates of how much work compaction is doing and can be compared that with an oprofile showing TLB misses and see if the cost of compaction is being offset by THP for example. Minimally a compaction patch can be evaluated in terms of whether it increases or decreases cost. The basic cost model looks like this Fundamental unit u: a word sizeof(void *) Ca = cost of struct page access = sizeof(struct page) / u Cmc = Cost migrate page copy = (Ca + PAGE_SIZE/u) * 2 Cmf = Cost migrate failure = Ca * 2 Ci = Cost page isolation = (Ca + Wi) where Wi is a constant that should reflect the approximate cost of the locking operation. Csm = Cost migrate scanning = Ca Csf = Cost free scanning = Ca Overall cost = (Csm * compact_migrate_scanned) + (Csf * compact_free_scanned) + (Ci * compact_isolated) + (Cmc * pgmigrate_success) + (Cmf * pgmigrate_failed) Where the values are read from /proc/vmstat. This is very basic and ignores certain costs such as the allocation cost to do a migrate page copy but any improvement to the model would still use the same vmstat counters. Signed-off-by: Mel Gorman Reviewed-by: Rik van Riel

mm: migrate: Add a tracepoint for migrate_pages

2012-12-11T14:28:35Z

The pgmigrate_success and pgmigrate_fail vmstat counters tells the user about migration activity but not the type or the reason. This patch adds a tracepoint to identify the type of page migration and why the page is being migrated. Signed-off-by: Mel Gorman Reviewed-by: Rik van Riel

mm: compaction: Move migration fail/success stats to migrate.c

2012-12-11T14:28:35Z

The compact_pages_moved and compact_pagemigrate_failed events are convenient for determining if compaction is active and to what degree migration is succeeding but it's at the wrong level. Other users of migration may also want to know if migration is working properly and this will be particularly true for any automated NUMA migration. This patch moves the counters down to migration with the new events called pgmigrate_success and pgmigrate_fail. The compact_blocks_moved counter is removed because while it was useful for debugging initially, it's worthless now as no meaningful conclusions can be drawn from its value. Signed-off-by: Mel Gorman Reviewed-by: Rik van Riel