user/sven/linux.git/net/packet, branch v4.2.8

packet: fix tpacket_snd max frame len

2015-12-15T05:25:35Z

[ Upstream commit 5cfb4c8d05b4409c4044cb9c05b19705c1d9818b ] Since it's introduction in commit 69e3c75f4d54 ("net: TX_RING and packet mmap"), TX_RING could be used from SOCK_DGRAM and SOCK_RAW side. When used with SOCK_DGRAM only, the size_max > dev->mtu + reserve check should have reserve as 0, but currently, this is unconditionally set (in it's original form as dev->hard_header_len). I think this is not correct since tpacket_fill_skb() would then take dev->mtu and dev->hard_header_len into account for SOCK_DGRAM, the extra VLAN_HLEN could be possible in both cases. Presumably, the reserve code was copied from packet_snd(), but later on missed the check. Make it similar as we have it in packet_snd(). Fixes: 69e3c75f4d54 ("net: TX_RING and packet mmap") Signed-off-by: Daniel Borkmann Acked-by: Willem de Bruijn Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

packet: infer protocol from ethernet header if unset

2015-12-15T05:25:35Z

[ Upstream commit c72219b75fde768efccf7666342282fab7f9e4e7 ] In case no struct sockaddr_ll has been passed to packet socket's sendmsg() when doing a TX_RING flush run, then skb->protocol is set to po->num instead, which is the protocol passed via socket(2)/bind(2). Applications only xmitting can go the path of allocating the socket as socket(PF_PACKET, , 0) and do a bind(2) on the TX_RING with sll_protocol of 0. That way, register_prot_hook() is neither called on creation nor on bind time, which saves cycles when there's no interest in capturing anyway. That leaves us however with po->num 0 instead and therefore the TX_RING flush run sets skb->protocol to 0 as well. Eric reported that this leads to problems when using tools like trafgen over bonding device. I.e. the bonding's hash function could invoke the kernel's flow dissector, which depends on skb->protocol being properly set. In the current situation, all the traffic is then directed to a single slave. Fix it up by inferring skb->protocol from the Ethernet header when not set and we have ARPHRD_ETHER device type. This is only done in case of SOCK_RAW and where we have a dev->hard_header_len length. In case of ARPHRD_ETHER devices, this is guaranteed to cover ETH_HLEN, and therefore being accessed on the skb after the skb_store_bits(). Reported-by: Eric Dumazet Signed-off-by: Daniel Borkmann Acked-by: Willem de Bruijn Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

packet: only allow extra vlan len on ethernet devices

2015-12-15T05:25:35Z

[ Upstream commit 3c70c132488794e2489ab045559b0ce0afcf17de ] Packet sockets can be used by various net devices and are not really restricted to ARPHRD_ETHER device types. However, when currently checking for the extra 4 bytes that can be transmitted in VLAN case, our assumption is that we generally probe on ARPHRD_ETHER devices. Therefore, before looking into Ethernet header, check the device type first. This also fixes the issue where non-ARPHRD_ETHER devices could have no dev->hard_header_len in TX_RING SOCK_RAW case, and thus the check would test unfilled linear part of the skb (instead of non-linear). Fixes: 57f89bfa2140 ("network: Allow af_packet to transmit +4 bytes for VLAN packets.") Fixes: 52f1454f629f ("packet: allow to transmit +4 byte in TX_RING slot for VLAN case") Signed-off-by: Daniel Borkmann Acked-by: Willem de Bruijn Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

packet: always probe for transport header

2015-12-15T05:25:35Z

[ Upstream commit 8fd6c80d9dd938ca338c70698533a7e304752846 ] We concluded that the skb_probe_transport_header() should better be called unconditionally. Avoiding the call into the flow dissector has also not really much to do with the direct xmit mode. While it seems that only virtio_net code makes use of GSO from non RX/TX ring packet socket paths, we should probe for a transport header nevertheless before they hit devices. Reference: http://thread.gmane.org/gmane.linux.network/386173/ Signed-off-by: Daniel Borkmann Acked-by: Jason Wang Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

packet: do skb_probe_transport_header when we actually have data

2015-12-15T05:25:35Z

[ Upstream commit efdfa2f7848f64517008136fb41f53c4a1faf93a ] In tpacket_fill_skb() commit c1aad275b029 ("packet: set transport header before doing xmit") and later on 40893fd0fd4e ("net: switch to use skb_probe_transport_header()") was probing for a transport header on the skb from a ring buffer slot, but at a time, where the skb has _not even_ been filled with data yet. So that call into the flow dissector is pretty useless. Lets do it after we've set up the skb frags. Fixes: c1aad275b029 ("packet: set transport header before doing xmit") Reported-by: Eric Dumazet Signed-off-by: Daniel Borkmann Acked-by: Jason Wang Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

packet: race condition in packet_bind

2015-12-09T19:31:07Z

[ Upstream commit 30f7ea1c2b5f5fb7462c5ae44fe2e40cb2d6a474 ] There is a race conditions between packet_notifier and packet_bind{_spkt}. It happens if packet_notifier(NETDEV_UNREGISTER) executes between the time packet_bind{_spkt} takes a reference on the new netdevice and the time packet_do_bind sets po->ifindex. In this case the notification can be missed. If this happens during a dev_change_net_namespace this can result in the netdevice to be moved to the new namespace while the packet_sock in the old namespace still holds a reference on it. When the netdevice is later deleted in the new namespace the deletion hangs since the packet_sock is not found in the new namespace' &net->packet.sklist. It can be reproduced with the script below. This patch makes packet_do_bind check again for the presence of the netdevice in the packet_sock's namespace after the synchronize_net in unregister_prot_hook. More in general it also uses the rcu lock for the duration of the bind to stop dev_change_net_namespace/rollback_registered_many from going past the synchronize_net following unlist_netdevice, so that no NETDEV_UNREGISTER notifications can happen on the new netdevice while the bind is executing. In order to do this some code from packet_bind{_spkt} is consolidated into packet_do_dev. import socket, os, time, sys proto=7 realDev='em1' vlanId=400 if len(sys.argv) > 1: vlanId=int(sys.argv[1]) dev='vlan%d' % vlanId os.system('taskset -p 0x10 %d' % os.getpid()) s = socket.socket(socket.PF_PACKET, socket.SOCK_RAW, proto) os.system('ip link add link %s name %s type vlan id %d' % (realDev, dev, vlanId)) os.system('ip netns add dummy') pid=os.fork() if pid == 0: # dev should be moved while packet_do_bind is in synchronize net os.system('taskset -p 0x20000 %d' % os.getpid()) os.system('ip link set %s netns dummy' % dev) os.system('ip netns exec dummy ip link del %s' % dev) s.close() sys.exit(0) time.sleep(.004) try: s.bind(('%s' % dev, proto+1)) except: print 'Could not bind socket' s.close() os.system('ip netns del dummy') sys.exit(0) os.waitpid(pid, 0) s.close() os.system('ip netns del dummy') sys.exit(0) Signed-off-by: Francesco Ruggeri Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

Fix AF_PACKET ABI breakage in 4.2

2015-10-03T11:51:38Z

[ Upstream commit d3869efe7a8a2298516d9af4f91487cf486ca945 ] Commit 7d82410950aa ("virtio: add explicit big-endian support to memory accessors") accidentally changed the virtio_net header used by AF_PACKET with PACKET_VNET_HDR from host-endian to big-endian. Since virtio_legacy_is_little_endian() is a very long identifier, define a vio_le macro and use that throughout the code instead of the hard-coded 'false' for little-endian. This restores the ABI to match 4.1 and earlier kernels, and makes my test program work again. Signed-off-by: David Woodhouse Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

packet: tpacket_snd(): fix signed/unsigned comparison

2015-07-29T07:09:58Z

tpacket_fill_skb() can return a negative value (-errno) which is stored in tp_len variable. In that case the following condition will be (but shouldn't be) true: tp_len > dev->mtu + dev->hard_header_len as dev->mtu and dev->hard_header_len are both unsigned. That may lead to just returning an incorrect EMSGSIZE errno to the user. Fixes: 52f1454f629fa ("packet: allow to transmit +4 byte in TX_RING slot for VLAN case") Signed-off-by: Alexander Drozdov Acked-by: Daniel Borkmann Signed-off-by: David S. Miller

packet: missing dev_put() in packet_do_bind()

2015-07-27T22:38:58Z

When binding a PF_PACKET socket, the use count of the bound interface is always increased with dev_hold in dev_get_by_{index,name}. However, when rebound with the same protocol and device as in the previous bind the use count of the interface was not decreased. Ultimately, this caused the deletion of the interface to fail with the following message: unregister_netdevice: waiting for dummy0 to become free. Usage count = 1 This patch moves the dev_put out of the conditional part that was only executed when either the protocol or device changed on a bind. Fixes: 902fefb82ef7 ('packet: improve socket create/bind latency in some cases') Signed-off-by: Lars Westerhoff Signed-off-by: Dan Carpenter Reviewed-by: Daniel Borkmann Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2015-06-24T09:58:51Z

Conflicts: drivers/net/ethernet/mellanox/mlx4/main.c net/packet/af_packet.c Both conflicts were cases of simple overlapping changes. Signed-off-by: David S. Miller