# Test machine.UART.IRQ_RXIDLE firing after a set of characters are received.
#
# IMPORTANT: This test requires hardware connections: the UART TX and RX
# pins must be wired together.

try:
    from machine import UART

    UART.IRQ_RXIDLE
except (ImportError, AttributeError):
    print("SKIP")
    raise SystemExit

import time, sys

# Target tuning options.
tune_wait_initial_rxidle = False

# Configure pins based on the target.
if "alif" in sys.platform:
    uart_id = 1
    tx_pin = None
    rx_pin = None
elif "esp32" in sys.platform:
    uart_id = 1
    tx_pin = 4
    rx_pin = 5
elif "mimxrt" in sys.platform:
    uart_id = 1
    tx_pin = None
elif "pyboard" in sys.platform:
    tune_wait_initial_rxidle = True
    if "STM32WB" in sys.implementation._machine:
        # LPUART(1) is on PA2/PA3
        uart_id = "LP1"
    else:
        # UART(4) is on PA0/PA1
        uart_id = 4
    tx_pin = None
    rx_pin = None
elif "renesas-ra" in sys.platform:
    uart_id = 9
    tx_pin = None  # P602 @ RA6M2
    rx_pin = None  # P601 @ RA6M2
elif "rp2" in sys.platform:
    uart_id = 0
    tx_pin = "GPIO0"
    rx_pin = "GPIO1"
elif "samd" in sys.platform and "ItsyBitsy M0" in sys.implementation._machine:
    uart_id = 0
    tx_pin = "D1"
    rx_pin = "D0"
    byte_by_byte = True
elif "samd" in sys.platform and "ItsyBitsy M4" in sys.implementation._machine:
    uart_id = 3
    tx_pin = "D1"
    rx_pin = "D0"
else:
    print("Please add support for this test on this platform.")
    raise SystemExit


def irq(u):
    print("IRQ_RXIDLE:", bool(u.irq().flags() & u.IRQ_RXIDLE), "data:", u.read())


text = ("12345678", "abcdefgh")

# Test that the IRQ is called for each set of byte received.
for bits_per_s in (2400, 9600, 115200):
    print("========")
    print("bits_per_s:", bits_per_s)

    if tx_pin is None:
        uart = UART(uart_id, bits_per_s)
    else:
        uart = UART(uart_id, bits_per_s, tx=tx_pin, rx=rx_pin)

    # Ignore a possible initial RXIDLE condition after creating UART.
    if tune_wait_initial_rxidle:
        uart.irq(lambda _: None, uart.IRQ_RXIDLE)
        time.sleep_ms(10)

    # Configure desired IRQ.
    uart.irq(irq, uart.IRQ_RXIDLE)

    for i in range(2):
        # Write data and wait for IRQ.
        print("write")
        uart.write(text[i])
        uart.flush()
        print("ready")
        time.sleep_ms(100)
        print("done")