Merge tag 'v5.0-rc6' into for-5.1/block

Pull in 5.0-rc6 to avoid a dumb merge conflict with fs/iomap.c.
This is needed since io_uring is now based on the block branch,
to avoid a conflict between the multi-page bvecs and the bits
of io_uring that touch the core block parts.

* tag 'v5.0-rc6': (525 commits)
  Linux 5.0-rc6
  x86/mm: Make set_pmd_at() paravirt aware
  MAINTAINERS: Update the ocores i2c bus driver maintainer, etc
  blk-mq: remove duplicated definition of blk_mq_freeze_queue
  Blk-iolatency: warn on negative inflight IO counter
  blk-iolatency: fix IO hang due to negative inflight counter
  MAINTAINERS: unify reference to xen-devel list
  x86/mm/cpa: Fix set_mce_nospec()
  futex: Handle early deadlock return correctly
  futex: Fix barrier comment
  net: dsa: b53: Fix for failure when irq is not defined in dt
  blktrace: Show requests without sector
  mips: cm: reprime error cause
  mips: loongson64: remove unreachable(), fix loongson_poweroff().
  sit: check if IPv6 enabled before calling ip6_err_gen_icmpv6_unreach()
  geneve: should not call rt6_lookup() when ipv6 was disabled
  KVM: nVMX: unconditionally cancel preemption timer in free_nested (CVE-2019-7221)
  KVM: x86: work around leak of uninitialized stack contents (CVE-2019-7222)
  kvm: fix kvm_ioctl_create_device() reference counting (CVE-2019-6974)
  signal: Better detection of synchronous signals
  ...

1 files changed, 17 insertions, 11 deletions

diff --git a/drivers/net/ethernet/cadence/macb_main.c b/drivers/net/ethernet/cadence/macb_main.c
index 66cc7927061a..2b2882615e8b 100644
--- a/drivers/net/ethernet/cadence/macb_main.c
+++ b/drivers/net/ethernet/cadence/macb_main.c
@@ -56,8 +56,7 @@
 /* level of occupied TX descriptors under which we wake up TX process */
 #define MACB_TX_WAKEUP_THRESH(bp)	(3 * (bp)->tx_ring_size / 4)
 
-#define MACB_RX_INT_FLAGS	(MACB_BIT(RCOMP) | MACB_BIT(RXUBR)	\
-				 | MACB_BIT(ISR_ROVR))
+#define MACB_RX_INT_FLAGS	(MACB_BIT(RCOMP) | MACB_BIT(ISR_ROVR))
 #define MACB_TX_ERR_FLAGS	(MACB_BIT(ISR_TUND)			\
 					| MACB_BIT(ISR_RLE)		\
 					| MACB_BIT(TXERR))
@@ -1270,7 +1269,7 @@ static int macb_poll(struct napi_struct *napi, int budget)
 				queue_writel(queue, ISR, MACB_BIT(RCOMP));
 			napi_reschedule(napi);
 		} else {
-			queue_writel(queue, IER, MACB_RX_INT_FLAGS);
+			queue_writel(queue, IER, bp->rx_intr_mask);
 		}
 	}
 
@@ -1288,7 +1287,7 @@ static void macb_hresp_error_task(unsigned long data)
 	u32 ctrl;
 
 	for (q = 0, queue = bp->queues; q < bp->num_queues; ++q, ++queue) {
-		queue_writel(queue, IDR, MACB_RX_INT_FLAGS |
+		queue_writel(queue, IDR, bp->rx_intr_mask |
 					 MACB_TX_INT_FLAGS |
 					 MACB_BIT(HRESP));
 	}
@@ -1318,7 +1317,7 @@ static void macb_hresp_error_task(unsigned long data)
 
 		/* Enable interrupts */
 		queue_writel(queue, IER,
-			     MACB_RX_INT_FLAGS |
+			     bp->rx_intr_mask |
 			     MACB_TX_INT_FLAGS |
 			     MACB_BIT(HRESP));
 	}
@@ -1372,14 +1371,14 @@ static irqreturn_t macb_interrupt(int irq, void *dev_id)
 			    (unsigned int)(queue - bp->queues),
 			    (unsigned long)status);
 
-		if (status & MACB_RX_INT_FLAGS) {
+		if (status & bp->rx_intr_mask) {
 			/* There's no point taking any more interrupts
 			 * until we have processed the buffers. The
 			 * scheduling call may fail if the poll routine
 			 * is already scheduled, so disable interrupts
 			 * now.
 			 */
-			queue_writel(queue, IDR, MACB_RX_INT_FLAGS);
+			queue_writel(queue, IDR, bp->rx_intr_mask);
 			if (bp->caps & MACB_CAPS_ISR_CLEAR_ON_WRITE)
 				queue_writel(queue, ISR, MACB_BIT(RCOMP));
 
@@ -1412,8 +1411,9 @@ static irqreturn_t macb_interrupt(int irq, void *dev_id)
 		/* There is a hardware issue under heavy load where DMA can
 		 * stop, this causes endless "used buffer descriptor read"
 		 * interrupts but it can be cleared by re-enabling RX. See
-		 * the at91 manual, section 41.3.1 or the Zynq manual
-		 * section 16.7.4 for details.
+		 * the at91rm9200 manual, section 41.3.1 or the Zynq manual
+		 * section 16.7.4 for details. RXUBR is only enabled for
+		 * these two versions.
 		 */
 		if (status & MACB_BIT(RXUBR)) {
 			ctrl = macb_readl(bp, NCR);
@@ -2259,7 +2259,7 @@ static void macb_init_hw(struct macb *bp)
 
 		/* Enable interrupts */
 		queue_writel(queue, IER,
-			     MACB_RX_INT_FLAGS |
+			     bp->rx_intr_mask |
 			     MACB_TX_INT_FLAGS |
 			     MACB_BIT(HRESP));
 	}
@@ -3907,6 +3907,7 @@ static const struct macb_config sama5d4_config = {
 };
 
 static const struct macb_config emac_config = {
+	.caps = MACB_CAPS_NEEDS_RSTONUBR,
 	.clk_init = at91ether_clk_init,
 	.init = at91ether_init,
 };
@@ -3928,7 +3929,8 @@ static const struct macb_config zynqmp_config = {
 };
 
 static const struct macb_config zynq_config = {
-	.caps = MACB_CAPS_GIGABIT_MODE_AVAILABLE | MACB_CAPS_NO_GIGABIT_HALF,
+	.caps = MACB_CAPS_GIGABIT_MODE_AVAILABLE | MACB_CAPS_NO_GIGABIT_HALF |
+		MACB_CAPS_NEEDS_RSTONUBR,
 	.dma_burst_length = 16,
 	.clk_init = macb_clk_init,
 	.init = macb_init,
@@ -4083,6 +4085,10 @@ static int macb_probe(struct platform_device *pdev)
 						macb_dma_desc_get_size(bp);
 	}
 
+	bp->rx_intr_mask = MACB_RX_INT_FLAGS;
+	if (bp->caps & MACB_CAPS_NEEDS_RSTONUBR)
+		bp->rx_intr_mask |= MACB_BIT(RXUBR);
+
 	mac = of_get_mac_address(np);
 	if (mac) {
 		ether_addr_copy(bp->dev->dev_addr, mac);