pinctrl: Add pin controller driver for AAEON UP boards

This enables the pin control support of the onboard FPGA on AAEON UP
boards.

This FPGA acts as a level shifter between the Intel SoC pins and the pin
header, and also as a mux or switch.

+---------+          +--------------+             +---+
          |          |              |             |   |
          | PWM0     |       \      |             | H |
          |----------|------  \-----|-------------| E |
          | I2C0_SDA |              |             | A |
Intel SoC |----------|------\       |             | D |
          | GPIO0    |       \------|-------------| E |
          |----------|------        |             | R |
          |          |     FPGA     |             |   |
----------+          +--------------+             +---+

For most of the pins, the FPGA opens/closes a switch to enable/disable
the access to the SoC pin from a pin header.
Each switch, has a direction flag that is set depending the status of the
SoC pin.

For some other pins, the FPGA acts as a mux, and routes one pin (or the
other one) to the header.

The driver also provides a GPIO chip. It requests SoC pins in GPIO mode,
and drives them in tandem with FPGA pins (switch/mux direction).

This commit adds support only for UP Squared board.

Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Thomas Richard <thomas.richard@bootlin.com>
Link: https://lore.kernel.org/20250811-aaeon-up-board-pinctrl-support-v9-10-29f0cbbdfb30@bootlin.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

1 files changed, 19 insertions, 0 deletions

diff --git a/drivers/pinctrl/Kconfig b/drivers/pinctrl/Kconfig
index ddd11668457c..463cf252c275 100644
--- a/drivers/pinctrl/Kconfig
+++ b/drivers/pinctrl/Kconfig
@@ -600,6 +600,25 @@ config PINCTRL_TH1520
 	  This driver is needed for RISC-V development boards like
 	  the BeagleV Ahead and the LicheePi 4A.
 
+config PINCTRL_UPBOARD
+	tristate "AAeon UP board FPGA pin controller"
+	depends on MFD_UPBOARD_FPGA
+	select PINMUX
+	select GENERIC_PINCTRL_GROUPS
+	select GENERIC_PINMUX_FUNCTIONS
+	select GPIOLIB
+	select GPIO_AGGREGATOR
+	help
+	  Pin controller for the FPGA GPIO lines on UP boards. Due to the
+	  hardware layout, the driver controls the FPGA pins in tandem with
+	  their corresponding Intel SoC GPIOs.
+
+	  Currently supported:
+	  - UP Squared
+
+	  To compile this driver as a module, choose M here: the module
+	  will be called pinctrl-upboard.
+
 config PINCTRL_ZYNQ
 	bool "Pinctrl driver for Xilinx Zynq"
 	depends on ARCH_ZYNQ || COMPILE_TEST