diff options
Diffstat (limited to 'include/linux/platform_data')
| -rw-r--r-- | include/linux/platform_data/bcmgenet.h | 19 | ||||
| -rw-r--r-- | include/linux/platform_data/lp855x.h | 4 | ||||
| -rw-r--r-- | include/linux/platform_data/spi-davinci.h | 73 |
3 files changed, 2 insertions, 94 deletions
diff --git a/include/linux/platform_data/bcmgenet.h b/include/linux/platform_data/bcmgenet.h deleted file mode 100644 index d8f8738629d2..000000000000 --- a/include/linux/platform_data/bcmgenet.h +++ /dev/null @@ -1,19 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0 */ -#ifndef __LINUX_PLATFORM_DATA_BCMGENET_H__ -#define __LINUX_PLATFORM_DATA_BCMGENET_H__ - -#include <linux/types.h> -#include <linux/if_ether.h> -#include <linux/phy.h> - -struct bcmgenet_platform_data { - bool mdio_enabled; - phy_interface_t phy_interface; - int phy_address; - int phy_speed; - int phy_duplex; - u8 mac_address[ETH_ALEN]; - int genet_version; -}; - -#endif diff --git a/include/linux/platform_data/lp855x.h b/include/linux/platform_data/lp855x.h index ab222dd05bbc..3b4a891acefe 100644 --- a/include/linux/platform_data/lp855x.h +++ b/include/linux/platform_data/lp855x.h @@ -124,12 +124,12 @@ struct lp855x_rom_data { }; /** - * struct lp855x_platform_data + * struct lp855x_platform_data - lp855 platform-specific data * @name : Backlight driver name. If it is not defined, default name is set. * @device_control : value of DEVICE CONTROL register * @initial_brightness : initial value of backlight brightness * @period_ns : platform specific pwm period value. unit is nano. - Only valid when mode is PWM_BASED. + * Only valid when mode is PWM_BASED. * @size_program : total size of lp855x_rom_data * @rom_data : list of new eeprom/eprom registers */ diff --git a/include/linux/platform_data/spi-davinci.h b/include/linux/platform_data/spi-davinci.h deleted file mode 100644 index 2cb5cc70fd9d..000000000000 --- a/include/linux/platform_data/spi-davinci.h +++ /dev/null @@ -1,73 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0-or-later */ -/* - * Copyright 2009 Texas Instruments. - */ - -#ifndef __ARCH_ARM_DAVINCI_SPI_H -#define __ARCH_ARM_DAVINCI_SPI_H - -#include <linux/platform_data/edma.h> - -#define SPI_INTERN_CS 0xFF - -enum { - SPI_VERSION_1, /* For DM355/DM365/DM6467 */ - SPI_VERSION_2, /* For DA8xx */ -}; - -/** - * davinci_spi_platform_data - Platform data for SPI master device on DaVinci - * - * @version: version of the SPI IP. Different DaVinci devices have slightly - * varying versions of the same IP. - * @num_chipselect: number of chipselects supported by this SPI master - * @intr_line: interrupt line used to connect the SPI IP to the ARM interrupt - * controller withn the SoC. Possible values are 0 and 1. - * @cshold_bug: set this to true if the SPI controller on your chip requires - * a write to CSHOLD bit in between transfers (like in DM355). - * @dma_event_q: DMA event queue to use if SPI_IO_TYPE_DMA is used for any - * device on the bus. - */ -struct davinci_spi_platform_data { - u8 version; - u8 num_chipselect; - u8 intr_line; - u8 prescaler_limit; - bool cshold_bug; - enum dma_event_q dma_event_q; -}; - -/** - * davinci_spi_config - Per-chip-select configuration for SPI slave devices - * - * @wdelay: amount of delay between transmissions. Measured in number of - * SPI module clocks. - * @odd_parity: polarity of parity flag at the end of transmit data stream. - * 0 - odd parity, 1 - even parity. - * @parity_enable: enable transmission of parity at end of each transmit - * data stream. - * @io_type: type of IO transfer. Choose between polled, interrupt and DMA. - * @timer_disable: disable chip-select timers (setup and hold) - * @c2tdelay: chip-select setup time. Measured in number of SPI module clocks. - * @t2cdelay: chip-select hold time. Measured in number of SPI module clocks. - * @t2edelay: transmit data finished to SPI ENAn pin inactive time. Measured - * in number of SPI clocks. - * @c2edelay: chip-select active to SPI ENAn signal active time. Measured in - * number of SPI clocks. - */ -struct davinci_spi_config { - u8 wdelay; - u8 odd_parity; - u8 parity_enable; -#define SPI_IO_TYPE_INTR 0 -#define SPI_IO_TYPE_POLL 1 -#define SPI_IO_TYPE_DMA 2 - u8 io_type; - u8 timer_disable; - u8 c2tdelay; - u8 t2cdelay; - u8 t2edelay; - u8 c2edelay; -}; - -#endif /* __ARCH_ARM_DAVINCI_SPI_H */ |