diff options
Diffstat (limited to 'tools/testing/selftests/drivers')
4 files changed, 114 insertions, 5 deletions
diff --git a/tools/testing/selftests/drivers/net/bonding/Makefile b/tools/testing/selftests/drivers/net/bonding/Makefile index 2b10854e4b1e..44b98f17f8ff 100644 --- a/tools/testing/selftests/drivers/net/bonding/Makefile +++ b/tools/testing/selftests/drivers/net/bonding/Makefile @@ -10,7 +10,8 @@ TEST_PROGS := \ mode-2-recovery-updelay.sh \ bond_options.sh \ bond-eth-type-change.sh \ - bond_macvlan_ipvlan.sh + bond_macvlan_ipvlan.sh \ + bond_passive_lacp.sh TEST_FILES := \ lag_lib.sh \ diff --git a/tools/testing/selftests/drivers/net/bonding/bond_passive_lacp.sh b/tools/testing/selftests/drivers/net/bonding/bond_passive_lacp.sh new file mode 100755 index 000000000000..9c3b089813df --- /dev/null +++ b/tools/testing/selftests/drivers/net/bonding/bond_passive_lacp.sh @@ -0,0 +1,105 @@ +#!/bin/bash +# SPDX-License-Identifier: GPL-2.0 +# +# Test if a bond interface works with lacp_active=off. + +# shellcheck disable=SC2034 +REQUIRE_MZ=no +NUM_NETIFS=0 +lib_dir=$(dirname "$0") +# shellcheck disable=SC1091 +source "$lib_dir"/../../../net/forwarding/lib.sh + +# shellcheck disable=SC2317 +check_port_state() +{ + local netns=$1 + local port=$2 + local state=$3 + + ip -n "${netns}" -d -j link show "$port" | \ + jq -e ".[].linkinfo.info_slave_data.ad_actor_oper_port_state_str | index(\"${state}\") != null" > /dev/null +} + +check_pkt_count() +{ + RET=0 + local ns="$1" + local iface="$2" + + # wait 65s, one per 30s + slowwait_for_counter 65 2 tc_rule_handle_stats_get \ + "dev ${iface} egress" 101 ".packets" "-n ${ns}" &> /dev/null +} + +setup() { + setup_ns c_ns s_ns + + # shellcheck disable=SC2154 + ip -n "${c_ns}" link add eth0 type veth peer name eth0 netns "${s_ns}" + ip -n "${c_ns}" link add eth1 type veth peer name eth1 netns "${s_ns}" + + # Add tc filter to count the pkts + tc -n "${c_ns}" qdisc add dev eth0 clsact + tc -n "${c_ns}" filter add dev eth0 egress handle 101 protocol 0x8809 matchall action pass + tc -n "${s_ns}" qdisc add dev eth1 clsact + tc -n "${s_ns}" filter add dev eth1 egress handle 101 protocol 0x8809 matchall action pass + + ip -n "${s_ns}" link add bond0 type bond mode 802.3ad lacp_active on lacp_rate fast + ip -n "${s_ns}" link set eth0 master bond0 + ip -n "${s_ns}" link set eth1 master bond0 + + ip -n "${c_ns}" link add bond0 type bond mode 802.3ad lacp_active off lacp_rate fast + ip -n "${c_ns}" link set eth0 master bond0 + ip -n "${c_ns}" link set eth1 master bond0 + +} + +trap cleanup_all_ns EXIT +setup + +# The bond will send 2 lacpdu pkts during init time, let's wait at least 2s +# after interface up +ip -n "${c_ns}" link set bond0 up +sleep 2 + +# 1. The passive side shouldn't send LACPDU. +check_pkt_count "${c_ns}" "eth0" && RET=1 +log_test "802.3ad lacp_active off" "init port" + +ip -n "${s_ns}" link set bond0 up +# 2. The passive side should not have the 'active' flag. +RET=0 +slowwait 2 check_port_state "${c_ns}" "eth0" "active" && RET=1 +log_test "802.3ad lacp_active off" "port state active" + +# 3. The active side should have the 'active' flag. +RET=0 +slowwait 2 check_port_state "${s_ns}" "eth0" "active" || RET=1 +log_test "802.3ad lacp_active on" "port state active" + +# 4. Make sure the connection is not expired. +RET=0 +slowwait 5 check_port_state "${s_ns}" "eth0" "distributing" +slowwait 10 check_port_state "${s_ns}" "eth0" "expired" && RET=1 +log_test "bond 802.3ad lacp_active off" "port connection" + +# After testing, disconnect one port on each side to check the state. +ip -n "${s_ns}" link set eth0 nomaster +ip -n "${s_ns}" link set eth0 up +ip -n "${c_ns}" link set eth1 nomaster +ip -n "${c_ns}" link set eth1 up +# Due to Periodic Machine and Rx Machine state change, the bond will still +# send lacpdu pkts in a few seconds. sleep at lease 5s to make sure +# negotiation finished +sleep 5 + +# 5. The active side should keep sending LACPDU. +check_pkt_count "${s_ns}" "eth1" || RET=1 +log_test "bond 802.3ad lacp_active on" "port pkt after disconnect" + +# 6. The passive side shouldn't send LACPDU anymore. +check_pkt_count "${c_ns}" "eth0" && RET=1 +log_test "bond 802.3ad lacp_active off" "port pkt after disconnect" + +exit "$EXIT_STATUS" diff --git a/tools/testing/selftests/drivers/net/bonding/config b/tools/testing/selftests/drivers/net/bonding/config index dad4e5fda4db..4d16a69ffc65 100644 --- a/tools/testing/selftests/drivers/net/bonding/config +++ b/tools/testing/selftests/drivers/net/bonding/config @@ -6,6 +6,7 @@ CONFIG_MACVLAN=y CONFIG_IPVLAN=y CONFIG_NET_ACT_GACT=y CONFIG_NET_CLS_FLOWER=y +CONFIG_NET_CLS_MATCHALL=m CONFIG_NET_SCH_INGRESS=y CONFIG_NLMON=y CONFIG_VETH=y diff --git a/tools/testing/selftests/drivers/net/napi_threaded.py b/tools/testing/selftests/drivers/net/napi_threaded.py index b2698db39817..9699a100a87d 100755 --- a/tools/testing/selftests/drivers/net/napi_threaded.py +++ b/tools/testing/selftests/drivers/net/napi_threaded.py @@ -35,6 +35,8 @@ def _setup_deferred_cleanup(cfg) -> None: threaded = cmd(f"cat /sys/class/net/{cfg.ifname}/threaded").stdout defer(_set_threaded_state, cfg, threaded) + return combined + def enable_dev_threaded_disable_napi_threaded(cfg, nl) -> None: """ @@ -49,7 +51,7 @@ def enable_dev_threaded_disable_napi_threaded(cfg, nl) -> None: napi0_id = napis[0]['id'] napi1_id = napis[1]['id'] - _setup_deferred_cleanup(cfg) + qcnt = _setup_deferred_cleanup(cfg) # set threaded _set_threaded_state(cfg, 1) @@ -62,7 +64,7 @@ def enable_dev_threaded_disable_napi_threaded(cfg, nl) -> None: nl.napi_set({'id': napi1_id, 'threaded': 'disabled'}) cmd(f"ethtool -L {cfg.ifname} combined 1") - cmd(f"ethtool -L {cfg.ifname} combined 2") + cmd(f"ethtool -L {cfg.ifname} combined {qcnt}") _assert_napi_threaded_enabled(nl, napi0_id) _assert_napi_threaded_disabled(nl, napi1_id) @@ -80,7 +82,7 @@ def change_num_queues(cfg, nl) -> None: napi0_id = napis[0]['id'] napi1_id = napis[1]['id'] - _setup_deferred_cleanup(cfg) + qcnt = _setup_deferred_cleanup(cfg) # set threaded _set_threaded_state(cfg, 1) @@ -90,7 +92,7 @@ def change_num_queues(cfg, nl) -> None: _assert_napi_threaded_enabled(nl, napi1_id) cmd(f"ethtool -L {cfg.ifname} combined 1") - cmd(f"ethtool -L {cfg.ifname} combined 2") + cmd(f"ethtool -L {cfg.ifname} combined {qcnt}") # check napi threaded is set for both napis _assert_napi_threaded_enabled(nl, napi0_id) |