summaryrefslogtreecommitdiff
path: root/drivers/tty/serial
AgeCommit message (Expand)Author
2023-06-28serial: lantiq: add missing interrupt ackBernhard Seibold
2023-06-28serial: lantiq: Do not swap register read/writesHauke Mehrtens
2023-06-28serial: lantiq: Use readl/writel instead of ltq_r32/ltq_w32Songjun Wu
2023-06-28serial: lantiq: Change ltq_w32_mask to asc_update_bitsSongjun Wu
2023-06-09tty: serial: fsl_lpuart: use UARTCTRL_TXINV to send break instead of UARTCTRL...Sherry Sun
2023-05-30serial: Add support for Advantech PCI-1611U cardVitaliy Tomin
2023-05-30serial: arc_uart: fix of_iomap leak in `arc_serial_probe`Ke Zhang
2023-05-30serial: 8250: Reinit port->pm on port specific driver unbindTony Lindgren
2023-05-17serial: 8250: Fix serial8250_tx_empty() race with DMA TxIlpo Järvinen
2023-05-17serial: 8250: Add missing wakeup event reportingFlorian Fainelli
2023-05-17tty: serial: fsl_lpuart: adjust buffer length to the intended sizeShenwei Wang
2023-04-20tty: serial: sh-sci: Fix Rx on RZ/G2L SCIBiju Das
2023-04-20tty: serial: sh-sci: Fix transmit end interrupt handlerBiju Das
2023-03-22serial: 8250_em: Fix UART port typeBiju Das
2023-03-11tty: serial: fsl_lpuart: disable the CTS when send break signalSherry Sun
2023-02-22serial: 8250_dma: Fix DMA Rx rearm raceIlpo Järvinen
2023-02-22serial: 8250_dma: Fix DMA Rx completion raceIlpo Järvinen
2023-01-24serial: atmel: fix incorrect baudrate setupTobias Schramm
2023-01-24serial: pch_uart: Pass correct sg to dma_unmap_sg()Ilpo Järvinen
2023-01-18serial: tegra: Change lower tolerance baud rate limit for tegra20 and tegra30Patrik John
2023-01-18serial: tegra: Only print FIFO error message when an error occursJon Hunter
2023-01-18tty: serial: tegra: Handle RX transfer in PIO mode if DMA wasn't startedDmitry Osipenko
2023-01-18serial: sunsab: Fix error handling in sunsab_init()Yuan Can
2023-01-18serial: altera_uart: fix locking in polling modeGabriel Somlo
2023-01-18tty: serial: altera_uart_{r,t}x_chars() need only uart_portJiri Slaby
2023-01-18tty: serial: clean up stop-tx part in altera_uart_tx_chars()Jiri Slaby
2023-01-18serial: pch: Fix PCI device refcount leak in pch_request_dma()Xiongfeng Wang
2023-01-18serial: pl011: Do not clear RX FIFO & RX interrupt in unthrottle.delisun
2023-01-18serial: amba-pl011: avoid SBSA UART accessing DMACR registerJiamei Xie
2023-01-18serial: tegra: Read DMA status before terminatingKartik
2023-01-18tty: serial: tegra: Activate RX DMA transfer by requestDmitry Osipenko
2023-01-18serial: tegra: Add PIO mode supportKrishna Yarlagadda
2023-01-18serial: tegra: report clk rate errorsKrishna Yarlagadda
2023-01-18serial: tegra: add support to adjust baud rateKrishna Yarlagadda
2023-01-18serial: tegra: add support to use 8 bytes triggerKrishna Yarlagadda
2023-01-18serial: tegra: set maximum num of uart ports to 8Krishna Yarlagadda
2023-01-18serial: tegra: check for FIFO mode enabled statusKrishna Yarlagadda
2023-01-18serial: tegra: avoid reg access when clk disabledAhung Cheng
2022-12-08serial: 8250: 8250_omap: Avoid RS485 RTS glitch on ->set_termios()Lukas Wunner
2022-11-25serial: 8250: Flush DMA Rx on RLSIIlpo Järvinen
2022-11-25serial: 8250_lpss: Configure DMA also w/o DMA filterIlpo Järvinen
2022-11-25serial: 8250: Fall back to non-DMA Rx if IIR_RDI occursIlpo Järvinen
2022-11-25serial: imx: Add missing .thaw_noirq hookShawn Guo
2022-11-25serial: 8250: omap: Flush PM QOS work on removeTony Lindgren
2022-11-25serial: 8250_omap: remove wait loop from Errata i202 workaroundMatthias Schiffer
2022-11-10parisc: Make 8250_gsc driver dependend on CONFIG_PARISCHelge Deller
2022-10-26serial: 8250: Fix restoring termios speed after suspendPali Rohár
2022-10-26drivers: serial: jsm: fix some leaks in probeDan Carpenter
2022-10-26tty: xilinx_uartps: Fix the ignore_statusShubhrajyoti Datta
2022-09-28serial: tegra: Use uart_xmit_advance(), fixes icount.tx accountingIlpo Järvinen
generated by cgit v1.2.3 (git 2.46.0) at 2026-01-06 02:39:27 +0000